« previous next »
Pages: [1]

Author Topic: KF Torque Specs  (Read 1485 times)

shadetree77

  • Full Member
  • ***
  • Posts: 198
    • View Profile
    • Email
KF Torque Specs
« on: January 18, 2015, 01:02:45 PM »
So throughout my use of the 1951 KF Service Manual I have noticed a SERIOUS lack of torque specs on a lot of things. Is there somewhere that contains this information? Case in point, I'm about to reconnect my tie rods to the idler lever and there are NO specs for the castle nuts. What did KF servicemen use for torque specs?
Logged
Robert Trail
Former Tech. Article Editor Buick Bugle Magazine
Former BCA#46402
Former KFOCI#10647

1953 Kaiser Manhattan
1952 Buick Special Deluxe (Lucy)
1951 Packard 300

shadetree77

  • Full Member
  • ***
  • Posts: 198
    • View Profile
    • Email
Re: KF Torque Specs
« Reply #1 on: January 18, 2015, 01:07:59 PM »
Just found the answer to my own question. I found the service standards manual which contains torque values. Geeze.....wish I had known this existed earlier.  :P
Logged
Robert Trail
Former Tech. Article Editor Buick Bugle Magazine
Former BCA#46402
Former KFOCI#10647

1953 Kaiser Manhattan
1952 Buick Special Deluxe (Lucy)
1951 Packard 300

dpledger

  • Full Member
  • ***
  • Posts: 236
    • View Profile
    • Email
Re: KF Torque Specs
« Reply #2 on: January 18, 2015, 10:03:21 PM »
Actually the shop manual has most of the torque data, but it is for the most part embedded in other sections. When describing how to install a part, it generally specifies how tight, if that is an issue.
Logged
Pages: [1]
« previous next »