Author Topic: Speedometer pinion gear repair  (Read 1868 times)

Fid

  • Hero Member
  • *****
  • Posts: 3853
    • View Profile
    • Email
Speedometer pinion gear repair
« on: February 03, 2017, 10:37:25 PM »
I know some have asked about where to get the speedometer drive pinion which fastens to the speedo cable. I bought an aftermarket speedo cable years ago and due to not fitting properly it ground up my speedo gear.  Luckily I had a spare but I've seen them advertised at www.walcks4wd.com so I thought I'd try to get a replacement so I'd have  a spare again.  The ones sold by Walcks are the gear only but I saved my worn one and replaced just gear head on it.  A bit spendy but it works.  I removed the old gear using a center punch.  Pressed the new one on using a vice which allowed me to press it on till the gear head was flush with the end of the shaft. After that, I took a brass bushing and put it on the end and back in the vice and it worked great so if you have a worn gear there is a fix. You just need to know how many teeth and order the appropriate replacement from Walcks
« Last Edit: February 10, 2017, 08:36:48 AM by Fid »
1953 Henry J Corsair Deluxe
Edgar Kaiser's custom 1951 Henry J
1951 Kaiser Special
1952 Allstate Deluxe

Need your classic car radio repaired? I repair vacuum tube radios

MarkH

  • Hero Member
  • *****
  • Posts: 1083
    • View Profile
    • Email
Re: Speedometer pinion gear repair
« Reply #1 on: February 04, 2017, 02:19:10 PM »
That's a nice fix, thanks for posting.
I've bought from Walcks before, I like that he lists factory numbers with his parts.
Fully restored '54 Aero Lark
Rusty '58 Austin Healey 100-Six
Barely running'74 Chevelle Malibu