Kaiser Frazer Owners Club Forum

General Category => General Discussion => Topic started by: MrLIts on December 13, 2022, 03:19:16 PM

Title: Trying to Mfg Darrin door plates / with spike
Post by: MrLIts on December 13, 2022, 03:19:16 PM

Any thoughts on how to proceed?  The die drawn area that holds the spike is the 4k question.   I imagine today I could 3D print that portion.  Or the whole thing. 

Title: Re: Trying to Mfg Darrin door plates / with spike
Post by: kaiserfrazerlibrary on December 14, 2022, 02:58:32 PM

If you are a club member, there are some resources available.  If you are not a member of the KFOCI I sincerely recommend you join.