Kaiser Frazer Owners Club Forum
General Category => Kaiser Forum => Topic started by: Jeff H on September 28, 2008, 02:25:38 PM
-
Hello
I picked up 4 water pump impellers and 2 bearings thinking they might fit my 134 L4 in my 1945 Willys MB. Well I was wrong!
The impeller box says 212337 I think, the last few numbers are hard to read. The bearing box says 207436. The actual bearing is a Federal FS-5169.
So I am not sure of exactly what these are for, but I bet someone here does.
I'd like to get $30 for the whole lot plus $10 Priority Mail shipping if someone out there is interested in buying these parts.
Thank you
Jeff H
(http://www.surfacezero.com/g503/data/500/medium/S5300136.JPG)
(http://www.surfacezero.com/g503/data/500/medium/S5300137.JPG)
(http://www.surfacezero.com/g503/data/500/medium/S5300138.JPG)
(http://www.surfacezero.com/g503/data/500/medium/S5300139.JPG)
(http://www.surfacezero.com/g503/data/500/medium/S5300140.JPG)
(http://www.surfacezero.com/g503/data/500/medium/S5300142.JPG)
-
212337 is a water pump repair kit for a Henry J, six cylinder. You have to be careful with the Henry J / Willys stuff because they could have either the 134 CID four cylinder or the 161 CID six cylinder and very few parts interchange between the 4 and 6 engines. A six cylinder Henry J water pump rebuild kit should be a good selling item. List it on on ebay and see what happens.
-
Hello
Thank you for the response. If the kit contained anything else like the clip, spring, and seal, I don't have any of that.
Just 4 impellers, (only 1 with a box not all 4), and the 2 bearings each with a box.
Are the bearings also for the Henry J?
If no one here is interested, then I will have to give ebay a try later.
Thanks
Jeff H
-
Ooops, sorry about that. There was no entry for 207436 in the Henry J parts book so I checked my 1951 Kaiser parts book. The bearing, part number 207436 is listed as "Waterpump Drive Shaft, including sleeve" which means that bearing is for a 1951 Kaiser (and probably all other Kaisers) which has the 226 CID Continental engine in it which is totally different than the engines mentioned before. They may be the same size physically, I've never compared, but that number is definitely not listed in the Henry J parts book, on the Kaiser.
-
Fid, is correct, the drive shafts are for 51-55 full size Kaisers. Terry Zeug lists them NOS for $5 each on his current parts list.
-
The parts have been spoken for , thank you all for your assistance !