Kaiser Frazer Owners Club Forum

General Category => General Discussion => Topic started by: Evan Crowell on May 15, 2013, 02:21:34 PM

Title: Oil Pressure sending unit
Post by: Evan Crowell on May 15, 2013, 02:21:34 PM

I'm in the precess of finishing up my 48 kaiser and I have an oil pressure sending unit, but I know where it goes. I cant seem to find it in the shop manual. If anyone has a picture of where it goes I would appreciate it.

Thanks!
 

Title: Re: Oil Pressure sending unit
Post by: Don C on May 15, 2013, 05:42:36 PM

the oil pressure unit goeson the bsck of the block under the rear of the manifold

Title: Re: Oil Pressure sending unit
Post by: Evan Crowell on May 15, 2013, 09:56:30 PM

thanks a lot!

Title: Re: Oil Pressure sending unit
Post by: kaiserfrazerlibrary on May 16, 2013, 07:04:56 AM

Check the K-F Shop Manual for location; it can also be attached on the oil line (figure one, Green cover 1948 issue book, Page 1 in Section One, General Egnine description).  The water temperature sender location is to the right in the photo, on the cylinder head.