Author Topic: Car cuts out - Electrical Problem?  (Read 2209 times)

jag52bkm

  • Newbie
  • *
  • Posts: 9
    • View Profile
    • Email
Car cuts out - Electrical Problem?
« on: July 21, 2008, 06:32:37 PM »
Intermittent problem while running the car cuts out.  Everything quits.  Ignition, headlights, running lights and acc.  It will start right up after 5 to 10 minutes and run fine till the next time and you never know when the next time will come.  Any ideas out there?

Thanks,
John
9763

DRAGON WHISPERER

  • Newbie
  • *
  • Posts: 6
    • View Profile
    • Email
Re: Car cuts out - Electrical Problem?
« Reply #1 on: August 06, 2008, 11:54:49 PM »

check your grounds for tightness, pull on them lightly as well to see if the terminal is still bonded corectly, next I would check the IGN switch next time to check for heat, could have a bad connection internaly. it definatly sounds like an electrical connection overheating then opening up, when it cools then reconnects. Ill ponder the next route and get back to you if I come up with a better bright idea :o

kaiserfrazerlibrary

  • Hero Member
  • *****
  • Posts: 3005
  • KFOCI Historian
    • AOL Instant Messenger - none
    • Yahoo Instant Messenger - none
    • View Profile
    • Email
Re: Car cuts out - Electrical Problem?
« Reply #2 on: August 10, 2008, 11:24:20 PM »
Here's a check lsit based on my experiences with 1951 and 1952 Kaisers:

1.  GROUND CABLE:  do you still have the braided type?  When was it last replaced?  If braided, disconnect it from the battery and soak it with a solution of baking soda and water.  If it bubbles and kind of sizzles you have corrosion issues.  Wiping it down with help but it should be replaced

2.  POSITIVE CABLE (to starter motor and beyond):  apply the same type solution as used on the ground to the terminal.  The cables and connectors may look ok but at 6 volts, good clean contacts are more critical than 12 volt systems.

The fact that you loose lights and everything, not just engine quitting suggest that one of these two cables (more likely the ground cable) are deteriorating.  Also, remember that K-F products are POSITIVE ground set-ups like the late 1940's early 1950's Chrysler products.