Messages

1

General Discussion / Re: 47 frazer popping out of 1st gear

« on: December 13, 2018, 11:24:37 PM »

The upper shift arm, which is low and reverse, is not connected to the shaft until the gear shift lever is pulled up to shift into low or reverse. Follow the procedure that joe outlined in the above post. Low and reverse do not have synchronizers and there are no adjustments that can be made inside the transmission.

Thank you all for the great advice! this is exactly what i need to kmow. The manual doesn't specifically say.

2

General Discussion / Re: 47 frazer popping out of 1st gear

« on: December 13, 2018, 06:43:40 PM »

I just noticed that this shift arm is not stationary in relation to the shaft. It this supposed to be fixed to the shifter shaft? I am able to move it freely without the shaft moving. I don’t see any way to tighten it to the shaft.

3

General Discussion / Re: 47 frazer popping out of 1st gear

« on: December 13, 2018, 05:12:37 PM »

Thank you so much! if, after adjusting the linkage...if that doesn't work, are the synchronizers something that is easily replaced without having to have the transmission rebuilt?

4

General Discussion / 47 frazer popping out of 1st gear

« on: December 13, 2018, 04:24:16 PM »

Hello all, i am new here, so thanks for the invite! I have just recently acquired a 47 Frazer from my dad. I am anxious to get it road worthy. It runs great and i just finished up redoing the whole brake system. The issue i am having now is that, when i shift into first gear and try to roll forward, the shifter pops out of gear. I am assuming that it is some type of linkage adjustment, but i was wanting to get some advice from anyone that may have had this issue before. Any help would be great. Thanks in advance!!