Author Topic: Engine manifold vacuum gauge reading  (Read 6766 times)

joefrazer

  • Hero Member
  • *****
  • Posts: 4043
    • View Profile
Re: Engine manifold vacuum gauge reading
« Reply #15 on: December 23, 2011, 03:27:34 PM »
Some of the cylinder head bolts do indeed go into the water jacket. I think the manifold studs do too. I know when I blew a head gasket on the 54, it was due to worn threads on a few of the head bolts that allowed coolant to work its way into the combustion chamber. If you cracked the block, you would have noticed an overheating condition.

A teardown of the engine would be a good idea.

boatingbill

  • Sr. Member
  • ****
  • Posts: 495
    • View Profile
    • Email
Re: Engine manifold vacuum gauge reading
« Reply #16 on: December 24, 2011, 12:42:16 AM »
Doc: I recently had a valve job on my '51 due to two stuck valves that I could not get loose. The
shop broke one bolt and replaced 5 more due to corrosion. When I picked the car up, the cost was $1. per bolt. I wished that they would have called me because I would have said replace then all.
I think there are 34 of them, so $34. would have been reasonable. Now I wonder if what happened
to you may happen to me, especially on a trip. The head looked like it had never been off and so
all bolts were original.

Doc

  • Hero Member
  • *****
  • Posts: 531
    • View Profile
    • Email
Re: Engine manifold vacuum gauge reading
« Reply #17 on: December 24, 2011, 09:23:09 AM »
At this point I cannot say about the bolts. But the engine was a total rebuild in the fall of 2009 and included vat clean complete motor, surface the head, guides, valves, freeze and galley plugs, bearings, bore and hone, deck block, grind crank, pins and bushings, etc. 
'54 Manhattan
'54 Late Special
'51 Frazer sedan

mbflemingkf

  • Hero Member
  • *****
  • Posts: 812
    • View Profile
    • Email
Re: Engine manifold vacuum gauge reading
« Reply #18 on: December 24, 2011, 12:49:17 PM »
So what hardness or type head bolts are we looking for?  I'm about to replace the head gasket on my 54 as well. Other opinions on replacing all head bolts during this process?
KFOCI #4818, Since 1982

Rear view mirror:
1954 Kaiser Manhattan, 4 Door (Now in FL)
1955 Kaiser Manhattan, 2 Door (Now in TX)
1953 Kaiser Manhattan, 4 Door (Now in Australia)
Thousands of parts & literature (All over the world)

boatingbill

  • Sr. Member
  • ****
  • Posts: 495
    • View Profile
    • Email
Re: Engine manifold vacuum gauge reading
« Reply #19 on: December 24, 2011, 06:35:43 PM »
I can't read my old ones, but the the new ones have 3 slash marks in the form of a "Y" which means a
grade 5 on the Rockwell hardness scale.

joefrazer

  • Hero Member
  • *****
  • Posts: 4043
    • View Profile
Re: Engine manifold vacuum gauge reading
« Reply #20 on: December 25, 2011, 12:27:34 PM »
You will want to use grade 8 cap screws. The problem is that the factory length is right in between the 2 most common sizes available thru most quality hardware outlets. I had to special order mine and they ran nearly $2 each...which was worth it to me to ensure that I had clean, fresh thread to work with.