« previous next »
Pages: [1]

Author Topic: Re-installing a 54 Manhattan heater  (Read 1177 times)

oldpm

  • Newbie
  • *
  • Posts: 48
    • View Profile
    • Email
Re-installing a 54 Manhattan heater
« on: April 14, 2012, 01:45:58 PM »
Hi All:

Where and how does the cone shaped device fit into the heater mechanism?

Barry
Logged

rialto

  • Full Member
  • ***
  • Posts: 230
    • View Profile
    • Email
Re: Re-installing a 54 Manhattan heater
« Reply #1 on: April 14, 2012, 04:31:09 PM »
That cone goes inside the heater box .The big end goes up against the heater core .The small end matches up to the round hole that faces the front seat. I will try to send a picture.
Logged

rialto

  • Full Member
  • ***
  • Posts: 230
    • View Profile
    • Email
Re: Re-installing a 54 Manhattan heater
« Reply #2 on: April 15, 2012, 03:09:16 PM »
Here is the picture I tried to send yesterday.
Logged

rialto

  • Full Member
  • ***
  • Posts: 230
    • View Profile
    • Email
Re: Re-installing a 54 Manhattan heater
« Reply #3 on: April 15, 2012, 03:21:49 PM »
The picture can enlarge .  #5 is the heater box. The round thing on the left is the cone installed inside it. I think the edge of the cone has a rubber gasket where it rests on the heater core.  I wish I had a better picture.
Logged

oldpm

  • Newbie
  • *
  • Posts: 48
    • View Profile
    • Email
Re: Re-installing a 54 Manhattan heater
« Reply #4 on: April 16, 2012, 07:06:47 PM »
Rialto,

Thanks very much for the information.  It has all come together.  I couldn't open the fot at first but I finally figured it out.

thanks again,  Barry
Logged
Pages: [1]
« previous next »