Author Topic: OD Relay Testing? (Read 1782 times)

mbflemingkf · « **on:** September 16, 2012, 10:56:54 AM »

Is there a way to "bench test" an OD relay to ensure its working properly? I have an NOS one but want to test it before selling it to ensure it will work as intended.

Thanks, Mike

joefrazer · « **Reply #1 on:** September 16, 2012, 03:57:26 PM »

Check your KF shop manual...any year and follow the directions to test. You can do this on a bench. I used page 311 of the 51 shop manual to troubleshoot the unit on my 50K and found the trouble (bad fuse connection).

Fid · « **Reply #2 on:** September 16, 2012, 05:02:09 PM »

If you have a 9 volt radio battery and a volt/ohm meter it's pretty easy. Touch the 9v battery terminals to the two terminals on the relay and see if it clicks. If it does click, connect the ohm meter/continuity tester to the other two terminals and click it again. The ohm meter should read 0 ohms or very close to it if the relay is working.
See this old thread for more details -
http://kfclub.com/forum/index.php/topic,592.msg2579.html#msg2579

mbflemingkf · « **Reply #3 on:** September 19, 2012, 10:42:35 PM »

Thanks guys. I have the later OD relay with the plug in on the bottom, 51-55. I tried the 9 volt battery but wasn't sure where to put the contacts so tried them on all 4 terminals. Didn't get a click.

84RabbitGTI · « **Reply #4 on:** September 21, 2012, 12:15:22 AM »

Can that relay be taken apart and cleaned up?

Kaiser Frazer Owners Club Forum

News:

Author Topic: OD Relay Testing? (Read 1782 times)

mbflemingkf

OD Relay Testing?

joefrazer

Re: OD Relay Testing?

Fid

Re: OD Relay Testing?

mbflemingkf

Re: OD Relay Testing?

84RabbitGTI

Re: OD Relay Testing?