« previous next »
Pages: [1]

Author Topic: Ignition switch 'stuck'  (Read 1480 times)

DaveF

  • Full Member
  • ***
  • Posts: 113
    • View Profile
    • Email
Ignition switch 'stuck'
« on: October 10, 2014, 02:30:47 PM »
Today when I started my 1952 Kaiser the switch remained in the 'start' position even though key retracted to 'on' position.  Had to disconnect battery to stop starter from spinning.  Tried turning key to all positions several times and 'rapped' on ignition body with a small hammer in hopes of perhaps un-sticking from start position...... No luck.  Any suggestions other than replacing switch?
Dave F. #10113
Logged

rialto

  • Full Member
  • ***
  • Posts: 230
    • View Profile
    • Email
Re: Ignition switch 'stuck'
« Reply #1 on: October 10, 2014, 08:34:14 PM »
The solenoid near the battery might be stuck.  Tap it and see if it releases. If it does you probably need a new solenoid.
Logged

pnw_oldmags

  • Administrator
  • Hero Member
  • *****
  • Posts: 1284
  • Personal Text
    • View Profile
    • CircleKF Website
    • Email
Re: Ignition switch 'stuck'
« Reply #2 on: October 10, 2014, 09:18:49 PM »
Starter switch may be too tight or not straight in the dash hole.
Logged
Jim Betts  LM6945
PNW Traveler Editor
CircleKF Webmaster
https://circlekf.com

DaveF

  • Full Member
  • ***
  • Posts: 113
    • View Profile
    • Email
Re: Ignition switch 'stuck'
« Reply #3 on: October 11, 2014, 08:42:07 PM »
Thanks guys!  Tapped on solenoid ....... It was stuck.
Logged

boatingbill

  • Sr. Member
  • ****
  • Posts: 495
    • View Profile
    • Email
Re: Ignition switch 'stuck'
« Reply #4 on: October 11, 2014, 08:48:46 PM »
If it stuck once, it will stick again so replace it. I saw this happen on a Dodge and the battery cables overheated
and caught the car on fire which froze the hood release cable and the car was destroyed.
Logged
Pages: [1]
« previous next »