Author Topic: HEAD LIGHT SWITCH REPAIR  (Read 756 times)

Terry T

  • Hero Member
  • *****
  • Posts: 1217
  • EX--Editor Darrin Newsletter/Registry
    • View Profile
    • Email
HEAD LIGHT SWITCH REPAIR
« on: November 01, 2016, 06:59:46 PM »
I would appreciate any help in trying to get the dash lights to work consistently.
There appears to be a dead zone in the rheostat dimmer--works when it wants to.

Can it be jumped/shorted so that the dash lights are on all the time?

dpledger

  • Full Member
  • ***
  • Posts: 236
    • View Profile
    • Email
Re: HEAD LIGHT SWITCH REPAIR
« Reply #1 on: November 01, 2016, 08:48:56 PM »
Sometimes polishing will fix this problem-get some very fine abrasive sheet between the arm and the coil and clean them up. If the coil is broken, this will not work. You can tap into the point on the coil corresponding to brightness you want, and then short this. Also could by pass the coil and substitute a fixed resister corresponding to the brightness you want.

G.B. (All Vinyl Dragon)

  • Hero Member
  • *****
  • Posts: 670
    • View Profile
    • Email
Re: HEAD LIGHT SWITCH REPAIR
« Reply #2 on: November 01, 2016, 08:56:17 PM »
On My 53 Dragon I have one to do swap out to get down the Road.
 Later I break it down, clean, & then light lube like W D - 40.
In electronics , Broadcast Transmitters, & or Radio - TV repair, We had a lot of good Products to do this. That was the Day We had manual tuners & control pots We had to renew.
It depends on Your climate as to how often.
Research on All Vinyl Dragons & Dragon List.
G.B. Bonham LM  K.F.O.C. Club.
Also: Vintage Electronics, TV, Stereo, Radio, & Broadcasting.
Looking for Kaye Halbert TV, 27 inch screen mid 50's
made in Culver City, Calif.