Kaiser Frazer Owners Club Forum

General Category => Kaiser Forum => Topic started by: Kory Fox on June 20, 2017, 10:32:24 AM

Title: Prepping parts for paint
Post by: Kory Fox on June 20, 2017, 10:32:24 AM

I am trying to get the duct pieces that fit between the inner fender and the firewall ready to paint. These are the pieces that have the flap inside that shuts off or allows air through. How can I remove surface rust and get them ready to paint without damaging the felt on the flap inside?

Title: Re: Prepping parts for paint
Post by: joefrazer on June 20, 2017, 07:44:15 PM

I ended up hand sanding the ducts on my 50K. I thought about soda blasting but I figured I'd slip and ruin the seals.

Title: Re: Prepping parts for paint
Post by: Kory Fox on June 20, 2017, 07:57:49 PM

What did you use to sand? Seems like it will be hard to get inside and all the nooks and crannies. I was thinking about one of the chemicals strippers but figured that might hurt the seals.

Title: Re: Prepping parts for paint
Post by: joefrazer on June 20, 2017, 08:19:01 PM

I rolled 220 wet/dry paper around two fingers and wet sanded everything. The factory paint is thin so it came off easily. Then, I washed everything with soap and water and let everything dry before painting.

Title: Re: Prepping parts for paint
Post by: Kory Fox on June 20, 2017, 08:30:08 PM

Ok. I'll give it a shot. Anyone know where I can get the cables that open and close them?

Title: Re: Prepping parts for paint
Post by: Kory Fox on June 22, 2017, 05:58:40 AM

Nobody knows where I can find the cables?

Title: Re: Prepping parts for paint
Post by: alohagreen on June 22, 2017, 09:19:34 AM

You are inside a post that ASK's about PREP FOR PAINT-----
go start a NEW post in parts wanted----