Kaiser Frazer Owners Club Forum
General Category => Kaiser Forum => Topic started by: Terry T on April 14, 2010, 07:49:52 PM
-
What is a current available part number for rear brake cylinders on 47-55 Kaisers? Ref. KF#200199
The casting number on the one I removed does not compute to current parts.
Thanks.
-
Terry - For some years the common replacement for the rear wheel cylinders on big KF products has been the cylinders as used on Willys Station Wagons & Trucks equipped with 226 engines. The only difference is that the steel line enters at an angle. Thus there are left & right part numbers where the original KF part was the same left & right. If you tweak the steel line, you can use the left on the right. I believe these replacements were available because there were still 4WD Willys vehicles in use out west.
-
I recently bought 4 new cylinders from Kaiser Willys http://www.kaiserwillys.com/ I had to drill 2 extra holes in the front right backing plate, but everything hooked up fine. Price was reasonable as well.
-
I recently bought two rear wheel cylinders from Kaiser Willy's also, I thought the price was very reasonable, considering we are talking about getting new parts for cars not made in over 55 years. Yes, I did have to bend the line abit, as mentioned, but that wasn't a problem, as the line is long enough, and worked great. CAUTION: use a hub puller to pull the drums off, not a drum puller, a hub puller will bolt up to the wheel bolts, and then you have the center right in. IF you use the type that grabs the sides of the drum, it may pull the drum from the outside, and bend it up. The lesson is to use the CORRECT tool, I will plead the 5th if you ask how I know, but all I will say is , I am waiting on my used drum to come in so I can finish the brake job. I will be ordering cylinders for the front. hope that helps.
-
Hi guys. I just had my '54 at the shop for a brake adjustment and he said my rear drums were way out of round and it seemed like someone had taken a torch to them. In fact, he could not get one of them off. He said he will need to heat it with a torch to do so, but that will ruin the drum even more and we want to have replacements ready before we do that. Can you recommend a good source for two rear drums?
He also said my front brake cylinders were leaking. Does Kaiser Willys have the fronts, too? Are they the same, or left and right? Thanks.
-
Front wheel cylinders on the big Kaisers are different side to side. The guts are the same, but how they mount does differ. KaiserWillys should have them. As for drums, they are not aftermarket available...your best bet is to try some of the parts vendors listed in the club's monthly bulletin.
-
Check with Larry Barker (The Kaiser Store) for '54 Brake Drums. Call him at 602-468-1403 or cell 602-373-1456. It may cost you quite a bit for USPS shipping, so you might want to have them shipped UPS Ground to save.
-
Thanks for the information on the cylinders and drums. I bought from Larry Barker before and was happy with the part. I will follow your advice.