Kaiser Frazer Owners Club Forum

General Category => Darrin Forum => Topic started by: joefrazer on August 07, 2010, 09:41:01 PM

Title: Hurricane 6 decal
Post by: joefrazer on August 07, 2010, 09:41:01 PM

Where, on a Darrin valve cover, should the 'Hurricane 6' decal be placed? I thought I had a photo of an original decal on one, but cannot find the photo at the moment. I'd like to make sure that mine ends up in the right place.

Title: Re: Hurricane 6 decal
Post by: kfnut on November 21, 2010, 09:59:54 AM

Check with Rick Kaman . He had the actual vave cover the decal was made from and it was still in place .

Title: Re: Hurricane 6 decal
Post by: kdar353 on February 17, 2012, 06:54:12 PM

Joe,
Did you get an answer to this question? If so where does it placed?
Thanks,
Bill #353

Title: Re: Hurricane 6 decal
Post by: darrin145 on February 22, 2012, 08:39:45 AM

If you go to page 1 of "darrin 145 hits the streets", you'll see an engine compartment photo where the decal is visible on the right side of the valve cover, below the oil fill cap about 1/2" above the "lip" of the cover. That's where the original decal was.

Gary.

Title: Re: Hurricane 6 decal
Post by: joefrazer on February 22, 2012, 03:51:04 PM

Oops...I meant to reply earlier...the post above is correct. It's mounted on the passenger side of the valve cover, just below the filler.

Title: Re: Hurricane 6 decal
Post by: kdar353 on February 24, 2012, 06:36:08 AM

You folks are the best!
Thanks, Bill

Title: Re: Hurricane 6 decal
Post by: Aeroman on April 27, 2012, 04:46:45 PM

I will try to remember to take a pic of the original valve cover that the decal was made from and post it. Someone call me at home tonite and remind me...