Kaiser Frazer Owners Club Forum

General Category => Henry J & Allstate Forum => Topic started by: Terry T on July 13, 2020, 12:18:19 PM

Title: MASTER CYLINDER REMOVAL
Post by: Terry T on July 13, 2020, 12:18:19 PM

is there a special tool to remove those LARGE Phillips head bolts on the outboard side?  you know, the ones without any clearance for a tool!!!!!!!!!!!!!!!!

Title: Re: MASTER CYLINDER REMOVAL
Post by: Corsairdeluxe on July 13, 2020, 05:24:12 PM

I bought a large,cheap Phillips head from Harbor freight. Heated it with a torch, bent and "Forged"one to fit

Title: Re: MASTER CYLINDER REMOVAL
Post by: mark leigh on July 13, 2020, 06:03:58 PM

You could use a flat bar and drill a hole through it - weld in a Phillips head tool bit --- easier to hold 

Title: Re: MASTER CYLINDER REMOVAL
Post by: G.B. (All Vinyl Dragon) on July 13, 2020, 06:17:01 PM

I have had this Happen before. I Used a Large Adjustable Wrench Upright, large Pipe or Screwdriver on Handle Hole.
I also spray WD 40 & let penetrate threads.  Don’t know How this happens? Could be Temperature when You tighten it  ?   

   

Title: Re: MASTER CYLINDER REMOVAL
Post by: Terry T on July 13, 2020, 08:07:40 PM

THANKS TO ALL