Kaiser Frazer Owners Club Forum

General Category => Henry J & Allstate Forum => Topic started by: Terry T on March 21, 2012, 11:13:44 AM

Title: Routing of cables thru FOD
Post by: Terry T on March 21, 2012, 11:13:44 AM

What cables, (vent, speedo, OD, and choke) go thru what holes in the front of dash?

Title: Re: Routing of cables thru FOD
Post by: Fid on March 21, 2012, 11:29:44 AM

Hi Terry, here's a picture of my '53 dash which is original. The '51 dash has one difference and that is the windsheild wiper knob; on the photo below, the wiper knob is mounted on the dash face, above the ignition switch, whereas on '51 and '52 Js (all models) it's located top center of the dash. Other than that, this is how they were originally -
(https://im1.shutterfly.com/media/47a4df32b3127ccef54e44d26a6c00000030O01SatmLdmyB7efAA/cC/f%3D0/ls%3D00203070160520140113231354555.JPG/ps%3D50/r%3D0/rx%3D550/ry%3D400/)
Add-on accessories such as overdrive and heater, were mounted below the dash using chrome hangers. The vent controls actually passed through the steering column molding as shown in the photo.
Let me know if this helps.

Title: Re: Routing of cables thru FOD
Post by: Terry T on March 21, 2012, 12:54:00 PM

Thanks, but I need to know what holes in the front of dash (formerly called "firewall") each cable goes thru.

Title: Re: Routing of cables thru FOD
Post by: Fid on March 21, 2012, 06:53:18 PM

Hi again Terry. I don't have any good pictures but I'll see if these will help - the choke cable and passenger side vent cable (if so equipped) were routed through the grommet with the two metal halves around it as seen here (upper right) -
(http://im1.shutterfly.com/media/47a1cf35b3127ccefec9a37cea8300000040O01SatmLdmyB7efAA/cC/f%3D0/ps%3D50/r%3D0/rx%3D550/ry%3D400/)

If the car did not have overdrive, the speedometer cable also comes through that same grommet as it must go to the passenger side of the trans unlike the OD equipped cars which the cable goes into the trans on the driver's side. If the car  has OD, the speedo cable comes through a grommet mounted about 11 o'clock position on the driver side air vent damper opening as shown here just to left of center (as viewing the photo) at the top -
(http://im1.shutterfly.com/media/47a1cf35b3127ccefec8b4298a0900000040O01SatmLdmyB7efAA/cC/f%3D0/ps%3D50/r%3D0/rx%3D550/ry%3D400/)
In this picture, I had the driver side vent damper out so I could install my new wire harness.

Title: Re: Routing of cables thru FOD
Post by: Terry T on March 26, 2012, 05:55:23 AM

Great pics.
Exactly what I needed.
Thanks.