Kaiser Frazer Owners Club Forum

General Category => Kaiser Forum => Topic started by: oldpm on April 14, 2012, 01:45:58 PM

Title: Re-installing a 54 Manhattan heater
Post by: oldpm on April 14, 2012, 01:45:58 PM

Hi All:

Where and how does the cone shaped device fit into the heater mechanism?

Barry

Title: Re: Re-installing a 54 Manhattan heater
Post by: rialto on April 14, 2012, 04:31:09 PM

That cone goes inside the heater box .The big end goes up against the heater core .The small end matches up to the round hole that faces the front seat. I will try to send a picture.

Title: Re: Re-installing a 54 Manhattan heater
Post by: rialto on April 15, 2012, 03:09:16 PM

Here is the picture I tried to send yesterday.

Title: Re: Re-installing a 54 Manhattan heater
Post by: rialto on April 15, 2012, 03:21:49 PM

The picture can enlarge .  #5 is the heater box. The round thing on the left is the cone installed inside it. I think the edge of the cone has a rubber gasket where it rests on the heater core.  I wish I had a better picture.

Title: Re: Re-installing a 54 Manhattan heater
Post by: oldpm on April 16, 2012, 07:06:47 PM

Rialto,

Thanks very much for the information.  It has all come together.  I couldn't open the fot at first but I finally figured it out.

thanks again,  Barry