Messages

1

Willys Forum / Re: Clutch info needed

« on: November 09, 2017, 09:43:30 PM »

found the info on another site

2

Willys Forum / Clutch info needed

« on: November 09, 2017, 05:54:11 PM »

I'm going to put my clutch in tomorrow I think, looking it over everything seems ok , Question is there any kind of CLIP? that hold the throw out bearing in place?

49 jeepster

3

Willys Forum / Re: Drive shaft

« on: November 08, 2017, 08:41:03 PM »

I have been nothing but problems with this build, but think I've figure it out till next problem.   Finally got right bell housing, got a starter 12v, alternator, got it started.  now it seemed the drive shaft was too long, but after sitting looking at it today, I think I may have found the problem.  The bracket that the motor mount sets on was in backwards or wrong side.  I switched them around and it may have done the trick.  It moved the engine forward about 3 inches, ran out of day lite to finish it.

4

Willys Forum / Drive shaft

« on: November 07, 2017, 08:36:33 PM »

Does any one the the length  of the drive shaft on a jeepster?  4 or 6 cyl

5

Willys Forum / Re: Problem on my biuld

« on: November 04, 2017, 10:26:25 PM »

I think this was a four cylinder car at one time, I bought a project and think it was just all the junk they had left over... I'm about 3.5 inchs too big...   

my tranny

6

Willys Forum / Problem on my biuld

« on: November 04, 2017, 09:11:10 PM »

Ran into a problem today!

1949 jeepster but has a 52? 161F engine, well when to put the transmission in place today and won't fit... being a 6 cyl it's longer and set back to far..for tranny and drive shaft...

I thinking moving the engine forward just need ideas on motor mount setup.

7

Willys Forum / 161F engine

« on: November 02, 2017, 08:02:15 AM »

Hello

I bought a jeep the has the 161f engine in it, jeep people know little about it.  It seems the it more a Kaiser engine then anything else.

So my question is what carburetor goes on it.  I can seem to find any info on it.