Messages

1

Henry J & Allstate Forum / Re: Grant Steering Wheel adapter for Henry J

« on: September 19, 2019, 07:09:12 AM »

Would you be able to post a picture of the finished install?

2

Henry J & Allstate Forum / Re: type of frost plugs used

« on: July 29, 2019, 11:36:32 AM »

Thanks, lots of people have told me that. Hope it helps someone else.

3

Henry J & Allstate Forum / type of frost plugs used

« on: June 19, 2019, 08:57:30 AM »

I changed my frost plugs which are the cupped (?) type and they started to pop out and I was told I put them in backwards, convex in towards the block. Any advice/ pictures would be of help. I have rubber expansion plugs in now.

4

Henry J & Allstate Forum / Re: clutch return spring length

« on: February 13, 2019, 08:39:35 AM »

Thanks.

5

Henry J & Allstate Forum / Re: Allstates on the HEMMINGS blog

« on: February 13, 2019, 08:38:02 AM »

Thanks.

6

Henry J & Allstate Forum / Re: Allstates on the HEMMINGS blog

« on: February 11, 2019, 01:19:04 PM »

Link please.

7

Henry J & Allstate Forum / Re: clutch return spring length

« on: February 11, 2019, 01:18:16 PM »

My parts list shows two springs,
# 212730, spring, return, 29 coils
# 209790, spring, assist, 23 coils

8

Henry J & Allstate Forum / Re: clutch pin

« on: February 11, 2019, 09:14:18 AM »

Thank you again for the info.

9

Henry J & Allstate Forum / clutch return spring length

« on: February 11, 2019, 09:13:43 AM »

All the springs I have are completely shot and I asked Kaiserwillys about a replacement. their # 630593A measures out at about 6-1/4". Would someone know what length the stock spring is?

10

Henry J & Allstate Forum / clutch pin

« on: February 10, 2019, 08:44:12 AM »

Should the clutch piviot pin press into the front trany cover? Mine slips in, not tight.

11

Henry J & Allstate Forum / Re: repainting engine, removing cam gear to remove motor mount plate?

« on: February 10, 2019, 08:41:25 AM »

Thanks.

12

Henry J & Allstate Forum / repainting engine, removing cam gear to remove motor mount plate?

« on: February 07, 2019, 09:51:20 AM »

I wonder if I have to remove the motor plate or just leave it on and clean it and repaint?

What have you done to remove the cam gear on a 161? My pullers can't get behind gear. I'm thinking of heating gear then try and pry it off.

13

General Discussion / Re: Barbara Mueller

« on: January 28, 2019, 01:42:39 PM »

Glad to hear you are on the road to recovery. All the best.

14

Darrin Forum / Re: Source or codes for the correct dark green for the engine

« on: January 13, 2019, 06:51:46 PM »

My parts have a primer under the green.

15

Darrin Forum / Re: Source or codes for the correct dark green for the engine

« on: January 12, 2019, 07:34:19 PM »

Thanks.