Messages

1

Henry J & Allstate Forum / Allstate Trunk Script

« on: March 18, 2021, 02:22:08 PM »

Anyone have an Allstate trunk badge/script for sale? I know it’s a long shot but thought I would ask.

2

Henry J & Allstate Forum / Re: Allstate or Henry J 9" Brake Shoe

« on: December 10, 2019, 06:46:15 PM »

FYI Purchased from Cyberbrake on Ebay

3

Henry J & Allstate Forum / Re: Allstate or Henry J 9" Brake Shoe

« on: December 10, 2019, 06:44:59 PM »

Just confirmed the Velocity NB51 set from EBay is the correct set for the front brakes. They have the modern linings not asbestos though. $27.87 shipped, thx

4

Henry J & Allstate Forum / Re: Allstate or Henry J 9" Brake Shoe

« on: December 10, 2019, 12:09:25 AM »

Thanks for the responses, I will update what I find.

5

Henry J & Allstate Forum / 6 Cylinder Exhaust Header Pipe

« on: December 10, 2019, 12:08:24 AM »

Looking for a decent header pipe for 6 cylinder HJ or Allstate. Mine is damaged and trying to avoid the use of flex pipe over the transmission cross over member. I also read where a 4 cylinder header could be cut and the 6 cylinder flange could be welded on. Thx

6

Henry J & Allstate Forum / Allstate or Henry J 9" Brake Shoe

« on: December 04, 2019, 10:06:21 PM »

I have looked all over the internet for front brake shoes for my 1953 Allstate. Tried Bendix 1221/51, Centric 111.00510 and Bendix AB-51 with no luck. I purchased the velocity NB53 from Ebay but they are 11" and will not work. Any Ideas or are they long gone like the 6 cylinder HJ waterpump?

7

Henry J & Allstate Forum / 1953 Allstate 6 cylinder fuel pump

« on: November 13, 2019, 04:25:30 PM »

Does anyone know where I can buy a new pump? The one on my motor now is a dual purpose for the wipers. If not would a 4 cylinder fuel pump work? Where could I buy it?
Thx Greg

8

Henry J & Allstate Forum / Re: 1953 Allstate Photos / Parts / Refurb

« on: August 26, 2019, 12:55:21 AM »

Good luck on your rebuild! I am also rebuilding a 1953 Allstate, cardinal red.

9

Henry J & Allstate Forum / Henry J 6 Cylinder Water Pumps

« on: August 26, 2019, 12:53:20 AM »

I was able to rebuild my water pump using a 17104.83 Omix-Ada water pump bearing and a Gogoal Mechanical 5/8" seal from Amazon. You will have to reuse your pump vane assembly so make sure the back surface is stoned flat where the mechanical seal will ride. I was not able to find the little sap wire clip so I just used part of a cotter key. Since they are no longer remanufactured by Cardone I thought this might help out.