« previous next »
Pages: [1]

Author Topic: Lowering Blocks  (Read 1923 times)

stacks

  • Newbie
  • *
  • Posts: 35
    • View Profile
    • Email
Lowering Blocks
« on: October 28, 2008, 01:55:44 PM »
I need to lower the rear of my 51 Kaiser Special about 1 1/2 inches.  I have not found any lowering blocks of the right dimensions to fit.  Has anyone installed lowering blocks on their car?  If so, where did you find them?

Jack
Logged

Gordie

  • Hero Member
  • *****
  • Posts: 2495
    • MSN Messenger - gordies1@verizon.net
    • AOL Instant Messenger - Gordie
    • View Profile
    • Email
Re: Lowering Blocks
« Reply #1 on: October 29, 2008, 10:13:07 PM »
Try taking a leaf out of each of the rear springs.  Maybe you have heavy duty springs in the back.
Logged
Member #3151 Since June 1974
Vice President K.F.O.C.I. 2013-2017  President 2018-2019
'47 Graham Paige Frazer                                   
'51 Kaiser Deluxe club coupe       
'51 Kaiser customized convertible 
'52 Allstate serial#39
'53 Aero Eagle
'54 Aero Eagle Custom

47trev

  • Jr. Member
  • **
  • Posts: 69
    • View Profile
    • Email
Re: Lowering Blocks
« Reply #2 on: October 31, 2008, 03:51:33 PM »
I took three leafs out of each side and run 3 inch lowering blocks from pepboys on my 47.
Logged

stacks

  • Newbie
  • *
  • Posts: 35
    • View Profile
    • Email
Re: Lowering Blocks
« Reply #3 on: November 01, 2008, 06:51:57 AM »
I found a set at Night Prowlers.  They had the right deminsion 'U' bolts (3" center stud to center stud), which I could not find at the franchise auto parts places.  I plan to install them and then decide if the front end needs to be lowered.  If it does I will probably take the coil springs out and cut a single round out of them. 
Logged
Pages: [1]
« previous next »