« previous next »
Pages: [1]

Author Topic: sticking controls  (Read 1501 times)

Logan

  • Hero Member
  • *****
  • Posts: 891
    • View Profile
    • Email
sticking controls
« on: June 10, 2011, 07:06:36 AM »
Some of my fresh air vent controls are VERY stiff.  Should I use grease, 3-in-1, something else?  Is it possible to over lube them so that they won't stay in the right position?
Logged

joefrazer

  • Hero Member
  • *****
  • Posts: 4043
    • View Profile
Re: sticking controls
« Reply #1 on: June 10, 2011, 11:37:43 AM »
One can never use too much lube to keep the controls working. I prefer PB Blaster to get things freed up then I wet a rag in WD40 and run that up and down the cable. It'll soak thru the casing and keep the cable lubed too.
Logged

darrin145

  • Full Member
  • ***
  • Posts: 244
    • View Profile
    • Email
Re: sticking controls
« Reply #2 on: June 10, 2011, 12:04:52 PM »
Or,  visit a Tractor Supply, bicycle or motorcycle shop and pick up some cable lube.

Gary.
Logged

Kenn Evans II

  • Full Member
  • ***
  • Posts: 169
    • MSN Messenger - winslowcemeteries@gmail.com
    • View Profile
    • Email
Re: sticking controls
« Reply #3 on: June 10, 2011, 02:28:32 PM »
If your in a dusty location, if you can remove the cable from the housing, polish the cable with a 0000 steel wool and reinsert the cable and lubricate with the spray graphite.  It is a bit messy while your doing it but it beats a seized up cable on an open duct on a cold day.
Logged
Family of 1952 Kaiser Manhattan 1952 Kaiser Deluxe 1949 Kaiser Traveler 1961 Falcon Ranchero 1963 Galaxie 500 XL Conv. 1964 Cadillac Sovereign Landaulet combination ambulance hearse , 1970 Ford Truck F100 1972 Chevelle SS Conv.  1979 Chevrolet C100 KF Member # 10252

Logan

  • Hero Member
  • *****
  • Posts: 891
    • View Profile
    • Email
Re: sticking controls
« Reply #4 on: June 10, 2011, 03:31:09 PM »
Okay, thanks for many suggestions.  Good to know I can't overlube--I won't worry about it!
Logged
Pages: [1]
« previous next »