Author Topic: driveshaft attachment different on 51 and 53  (Read 1982 times)

Henry's HenryJs

  • Sr. Member
  • ****
  • Posts: 432
    • View Profile
    • Email
driveshaft attachment different on 51 and 53
« on: April 07, 2013, 07:40:41 AM »
On my 51 the driveshaft U joint trunion mounts directly to the trany slip yoke and to the diff yoke. On the 53 the driveshaft U joints mount to circular plates and then into a recess on circular plates on both the trany and diff yoke. You can see the trany flange in this 53 pic.
2-51 HenryJ's, 57 wagon 408"BB with 14' Bonair travel trailer,71 Nova 355"SB, 07 2500HD with 26.5 Prowler 5th wheel travel trailer, CDN coordinator for ChevyTalk
http://www.picturetrail.com/gallery/view?username=h

kaiserfrazerlibrary

  • Hero Member
  • *****
  • Posts: 3005
  • KFOCI Historian
    • AOL Instant Messenger - none
    • Yahoo Instant Messenger - none
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #1 on: April 07, 2013, 08:39:58 AM »
The 1951-53 HJ Factory Shop Manual shows both the ball and trunion and u-joint "cross and yoke" types were used on the cars.

The book covers component parts in the two assemblies and repair of same.

pnw_oldmags

  • Administrator
  • Hero Member
  • *****
  • Posts: 1284
  • Personal Text
    • View Profile
    • CircleKF Website
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #2 on: April 07, 2013, 08:51:28 AM »
Just in case you did not know that Shop Manual is online to assist in your repair.
http://circlekf.com/kflit/SM/kfsm580.html
Jim Betts  LM6945
PNW Traveler Editor
CircleKF Webmaster
https://circlekf.com

Corsairdeluxe

  • Hero Member
  • *****
  • Posts: 811
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #3 on: April 07, 2013, 01:33:18 PM »
Jim... Correct me if I'm wrong.Wern't spicers used on all O.D. cars?
Jim Brown aka Corsairdeluxe
#3559
10 Henrys and 1 ALLSTATE
behind me. J less at the moment and having irrational thoughts.

Fid

  • Hero Member
  • *****
  • Posts: 3854
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #4 on: April 07, 2013, 06:19:29 PM »
The Parts book lists the "Detroit" type (ball and trunion) was used on '53 Js without overdrive (likely to reduce noise/vibration) and the cross and yoke type were used on overdrive equipped cars. Both my '53s have OD and both have the cross and yoke type. Both are original/unmolested cars.
1953 Henry J Corsair Deluxe
Edgar Kaiser's custom 1951 Henry J
1951 Kaiser Special
1952 Allstate Deluxe

Need your classic car radio repaired? I repair vacuum tube radios

HJ-ETEX

  • Hero Member
  • *****
  • Posts: 640
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #5 on: May 04, 2013, 06:31:28 PM »
U-Joints: Henry Js started with Spicer types and then switched to ball & trunion for the true 52s and then switched back for 53.
I would dispute the claim that all OD cars had Spicer u-joints. I do have an OD drive shaft for my 52 Allstate that has ball & trunion u-joints. If you have an HJ or Allstate with a ball & trunion driveshaft, I would recommend switching out the trans and rear end flanges and use a Spicer equipped driveshaft.
KFOCI VP 2001-2005
1951 Kaiser Deluxe /327 Chevy
1951 Kaiser Deluxe (no funny stuff)
1968 Kaiser Commando V6
1961 Willys 2WD 134 F-Head SW
1963 Kaiser FC170

HJ-ETEX

  • Hero Member
  • *****
  • Posts: 640
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #6 on: May 04, 2013, 07:24:27 PM »
And you should know about the orientation of the driveshaft. On a HJ with Spicer joints, the end with the slip yoke goes on the transmission. If you put the slip yoke end at the rear end, it gathers water, dirt & grit and wears out.
One of the better HJs in the Club had the driveshaft on backwards for several years.
KFOCI VP 2001-2005
1951 Kaiser Deluxe /327 Chevy
1951 Kaiser Deluxe (no funny stuff)
1968 Kaiser Commando V6
1961 Willys 2WD 134 F-Head SW
1963 Kaiser FC170

Fid

  • Hero Member
  • *****
  • Posts: 3854
    • View Profile
    • Email
Re: driveshaft attachment different on 51 and 53
« Reply #7 on: June 22, 2013, 10:04:12 AM »
Quote
I would dispute the claim that all OD cars had Spicer u-joints. I do have an OD drive shaft for my 52 Allstate that has ball & trunion u-joints.

As I mentioned in the previous post, the parts book states that all 1953 Henry Js with OD have the Spicer u-joints so no, not all of them do. It also states that all '52 Js, except Vagabonds, have the ball and trunion. Since the Allstate you make reference to is a '52 it is consistent with the factory parts book.
« Last Edit: June 23, 2013, 12:36:50 AM by Fid »
1953 Henry J Corsair Deluxe
Edgar Kaiser's custom 1951 Henry J
1951 Kaiser Special
1952 Allstate Deluxe

Need your classic car radio repaired? I repair vacuum tube radios