Author Topic: Darrin gear oil  (Read 2359 times)

warren

  • Full Member
  • ***
  • Posts: 117
    • View Profile
    • Email
Darrin gear oil
« on: August 06, 2021, 12:54:11 PM »
What is the correct gear oil to use in the Darrin transmission  and rear axle?
'54 Darrin
'59 Ford Skyliner
'36 Dodge Coupe
'70 Cuda
'83 Jeep Scrambler
'67 Mustang

kaiserfrazerlibrary

  • Hero Member
  • *****
  • Posts: 3005
  • KFOCI Historian
    • AOL Instant Messenger - none
    • Yahoo Instant Messenger - none
    • View Profile
    • Email
Re: Darrin gear oil
« Reply #1 on: August 08, 2021, 09:04:34 AM »
The Darrin Lubrication Chart is part of K-F Service Bulletin #416.  It shows SAE 80 weight gear oil for the 3-speed manual (with overdrive) gearbox, and SAE 90 weight gear oil in the differential.  It also notes about using SAE 90 if you are in hot climate areas.

Kaiser-Frazer or Willys never put out a regular Shop Manual on the Darrins.  KFOCI HANDBOOK has the complete set of K-F and K-W Service Bulletins issued on the car and can be used instead.  Note that the Service Bulletins indicate that for some issues, the 1951-1952-1953 Henry J Shop Manual is used for some mechanical issues, and the Willys Motors Mechanics Manual for the 685 and 226-6 engined Willys Cars is used for some engine and drivetrain issues.

I thought this was something the Darrin Registry handled for members?

MarkH

  • Hero Member
  • *****
  • Posts: 1083
    • View Profile
    • Email
Re: Darrin gear oil
« Reply #2 on: August 08, 2021, 10:14:59 AM »
There's "GL (1/2/3/4/5?)" ratings if I remember right. Most important is one without additives that attack the bronze parts in the T-96. I'll check in my shop later what I used in my Aero & post it.  I think you have a HJ rear axle, lube as indicated above.
Fully restored '54 Aero Lark
Rusty '58 Austin Healey 100-Six
Barely running'74 Chevelle Malibu

MarkH

  • Hero Member
  • *****
  • Posts: 1083
    • View Profile
    • Email
Re: Darrin gear oil
« Reply #3 on: August 08, 2021, 12:48:14 PM »
Here's what I used:
Napa GL1 90 weight mineral oil. I had to buy a gallon, but there's also other sources. Be sure to fill the trans & overdrive separately.

I used Royal Purple 10/30w high zinc break-in oil on my engine & was getting an intermittent low pressure light. It was so thin on the dipstick I got spooked & changed it out to Lucas 30w high zinc break-in oil, & plumbed in a mechanical pressure gauge at the front oil gallery plug next to the fuel pump. Turns out I had good pressure & a bad NOS sender unit, but kept the gauge till permanent oil recently went in after 500mi.
I've never been a big fan of multi weight oil in older engines due to lower pressure in the past but decided to try this oil after researching viscosity ranges & comparing to their specs. Their 15/40 oil is running the same pressure full hot in 90 degree weather as the straight 30. Downside is it's 12qt boxes & $20 shipping. https://inrccca.org/product/classic-car-motor-oil/#:~:text=Classic%20Car%20Motor%20Oil%20has%20been%20designed%20to,the%20car%20is%20stored%20and%20not%20run%20frequently.
« Last Edit: August 08, 2021, 06:27:38 PM by MarkH »
Fully restored '54 Aero Lark
Rusty '58 Austin Healey 100-Six
Barely running'74 Chevelle Malibu

Terry T

  • Hero Member
  • *****
  • Posts: 1217
  • EX--Editor Darrin Newsletter/Registry
    • View Profile
    • Email
Re: Darrin gear oil
« Reply #4 on: September 26, 2021, 04:37:29 PM »
use 30W for the engine with proper API' SJ or higher for good ZDDP content

Terry T

  • Hero Member
  • *****
  • Posts: 1217
  • EX--Editor Darrin Newsletter/Registry
    • View Profile
    • Email
Re: Darrin gear oil
« Reply #5 on: September 26, 2021, 05:31:43 PM »
GL1 is a bargain at TSC