« previous next »
Pages: [1]

Author Topic: oil seal Hydramatic to drive shaft  (Read 1116 times)

Marse

  • Newbie
  • *
  • Posts: 14
    • View Profile
    • Email
oil seal Hydramatic to drive shaft
« on: July 22, 2014, 02:15:11 PM »
Where can I get a replacement oil seal for the rear end of the hydramatic trans where the drive shaft enters the trans?  I have a 1951 4-door Kaiser 4-door deluxe sedan with a K50 GM HydraMatic Trans. The existing seal has a National P/N of 6010. This seal has a leather material/seal that rides on the drive shaft.  I don't know if this is correct for this car or not.  The drive shaft O.D. diameter is 1.5".  The O.D. of the 6010 seal (that fits into the trans) is approximately 2.156". 
I would appreciate any help you can give.

Marse - Tujunga, CA
Logged

mbflemingkf

  • Hero Member
  • *****
  • Posts: 812
    • View Profile
    • Email
Re: oil seal Hydramatic to drive shaft
« Reply #1 on: July 22, 2014, 07:21:52 PM »
NAPA 1-2727

 8)
Logged
KFOCI #4818, Since 1982

Rear view mirror:
1954 Kaiser Manhattan, 4 Door (Now in FL)
1955 Kaiser Manhattan, 2 Door (Now in TX)
1953 Kaiser Manhattan, 4 Door (Now in Australia)
Thousands of parts & literature (All over the world)

Marse

  • Newbie
  • *
  • Posts: 14
    • View Profile
    • Email
Re: oil seal Hydramatic to drive shaft
« Reply #2 on: July 22, 2014, 07:27:06 PM »
Thank you.  I'll ask my local NAPA dealer to check this out for me.

Marse

My local NAPA dealers cannot locate the 1-2727 seal nor the National  6010 seal which is presently on the car.  Anyone else have other sources or solutions?
Thank you,

Marse
« Last Edit: August 28, 2014, 12:23:51 PM by Marse »
Logged
Pages: [1]
« previous next »